horsch LEEB 12 TD, Руководство по эксплуатации, Страница: 112 / 181

a
b
c
d
e
At the beginning of the filling process the water
sucked in through the suction hose is applied to
the illuviation valve.
Once the desired tank contents is reached, the
suction valve will automatically switch over to
the spraying mixture container. Chemical is then
present at the illuviation valve.
Use the washing gun to remove any residues
from the illuviation valve. Pull lever (b) and
operate the gun to do so.
Make sure that no undesired point-type entries
of preparation are generated!
Flushing in liquid preparations
for full or partly filled spraying
mixture container on machines of
the CCS Pro variant
a
b
c
d
e
1. Open the lid on the illuviation valve.
2. Switch on the illuviation valve on the terminal.
3. Fill the required preparation quantity as
calculated for filling the tank into the illuviation
valve.
4. Turn the switch-over ball valve (e) to the
position for sucking-off. Have the content
completely sucked off from the illuviation
valve.
5. Close the switch-over ball valve (e) again.
The process may need to be repeated if the
required preparation could not be filled in
during a single process.
6. Pre-clean the illuviation valve with the closed
circuit flushing (d).
7. Open the switch-over ball valve and have the
contents sucked off.
8. Clean the illuviation valve with the washing
gun.
9. Close the switch-over ball valve (e) again.
10. Switch off the illuviation valve on the
terminal again.
11. Adjust the desired agitator power.
108 109