Section 14: Aileron and/or Quad-Flap Linkage Installation
39
Step 8
With the linkage attached to the control horn, center the
control surface and hold the linkage wire directly over the
electronically centered servo arm. Place a mark on the rod
directly over the hole (second hole from the end of arm)
in the servo control arm that it will connect to.
Step 9
Remove the clevis from the control horn. Make a
90-degree bend in the rod at the marked location
and cut off the excess rod, leaving 5/16" of rod past the
90-degree bend.
Step 10
Attach a wire keeper to the end of the rod with the
90-degree bend. Insert the 90-degree bend through the
second hole from the end of the servo arm and install the
end of the wire keeper over the end of the wire. Install the
clevis back onto the control horn. Be sure to slide the
silicon clevis keeper on the end of the clevis.
Step 11
Repeat the process for the remainder of the
aileron/flaps linkages.
