HYDROSTIK PRO_UM_121031
9
(5)
Place the HYDROSTIK PRO into the tub full of water so that it lies horizontally under
the water. Slowly turn the dual headed pressure regulator valve clockwise, making sure
you watch the left-handed pressure reading (Fig. 9&10). When it reaches 30Bar
(435PSI) allow the metal hydride cartridge to fill for about 30 minutes.
And then turn the dual headed pressure regulator valve anti-clockwise until it is
tight to check if the dial moves slowly towards zero. If the dial does not move that
means the cartridge is fully filled. If the dial moves down continuously, please turn the
headed pressure regulator to 30Bar (435PSI) for continuous charging.
(6)
Turn off the dual headed pressure regulator anti-clockwise until it is closed. At this
time the lower pressure meter still indicates the pressure you charged the cartridge.
Disconnect the HYDROSTIK PRO from the hydrogen cable. The meter will be back to 0
(Fig. 11&12).
(7)
Use the wrench to disconnect the hydrogen cable from the pressure regulator and turn
the hydrogen supply off if not use them anymore (Fig. 13).
Fig. 9
Fig. 10
Fig. 11
Fig. 12
Fig. 13
