HYDROSTIK PRO_UM_121031
8
(3)
Turn the duel headed pressure regulator handle anti-clockwise until it is tight. Make sure
it is in the closed condition, so that the dual pressure regulator shows a zero reading on
both dials (Fig. 5&6).
Inspect the connections for leaks by applying some soap water on all connections.
If you notice bubbles appearing please close the cylinder valve, stop the
procedure and contact your professional suppliers for technical support.
Also if the cylinder’s pressure is lower than 30Bar (435PSI), stop using this cylinder
because the pressure is too low to charge the cartridge.
Before connecting the HYDROSTIK PRO, turn on the dual headed pressure regulator
valve clockwise to 1Bar (14.5PSI) to release the impure gases out of the tube. Repeat
this 2-3 times for pure gases used in the next hydrogen charging process.
(4)
Prepare a plastic tub that the metal hydride cartridge can lie in horizontally, with enough
water (ambient temperature) to cover the metal hydride cartridge. Holding the other end
of the hydrogen cable, connect the HYDROSTIK PRO metal hydride cartridge to the
cable by turning the cartridge clockwise until it is securely fastened to the cable (Fig.
7&8).
CAUTION
NOTE
IMPORTANT
Fig. 5
Fig. 6
Fig. 7
Fig. 8
