Honeywell Lyric LCP300-LC, Инструкция по установке и справочник

Страница: 27 / 48

Lyric Gateway Installation and Reference Guide
- 27 -
Testing the System Testing the System Testing the System Testing the System (Continued)
Go Go Go Go----No No No No----Go Test Go Test Go Test Go Test Mode Mode Mode Mode
Conducting this test with your hand wrapped around the transmitter will cause inaccurate results.
Conducting this test with your hand wrapped around the transmitter will cause inaccurate results. Conducting this test with your hand wrapped around the transmitter will cause inaccurate results.
Conducting this test with your hand wrapped around the transmitter will cause inaccurate results.
If a button is pressed on a transmitter tha
If a button is pressed on a transmitter tha If a button is pressed on a transmitter tha If a button is pressed on a transmitter that has been programmed to set t has been programmed to set t has been programmed to set t has been programmed to set Arm Away, Arm Arm Away, Arm Arm Away, Arm Arm Away, Arm Home Home Home Home
((((Stay Stay Stay Stay)))), or , or , or , or Disarm Disarm Disarm Disarm, the system will exit the Go/No Go Test mode and the programmed action will , the system will exit the Go/No Go Test mode and the programmed action will , the system will exit the Go/No Go Test mode and the programmed action will , the system will exit the Go/No Go Test mode and the programmed action will
occur.
occur. occur.
occur.
The Go-No-Go tests is used to verify adequate RF signal strength from the proposed transmitter location, and
allow you to reorient or relocate transmitters if necessary, before mounting the transmitters permanently. This
mode is similar to the RF Sniffer Mode, except that the wireless receiver gain is reduced. This will enable you to
make sure that the RF signal from each transmitter is received with sufficient signal amplitude when the system
is in the normal operating mode. During Go/No-Go mode the system beeps every 30-40 seconds.
Enter Go/No
Enter Go/No Enter Go/No
Enter Go/No----Go Test mode
Go Test mode Go Test mode
Go Test mode
1. Enter Installer Code (4112) + 51 (on the Gateway touchpad).
Exit Go/No Exit Go/No Exit Go/No Exit Go/No----Go Test mode Go Test mode Go Test mode Go Test mode
1. Select “Di Enter Installer Code (4112).
Rebooting the System
Rebooting the System Rebooting the System
Rebooting the System
The Reboot function allows you to restart the system if required. To reboot the system perform the following
via the AlarmNet 360 app when the “Advanced” icon is selected from the Installer Tools screen or the Installer
Programming screen.
Step Step Step Step Action Action Action Action
1. Select the “Reboot” button. A confirmation screen appears.
2. Select “Yes” to reboot the Gateway.
NOTE NOTE NOTE NOTE:::: After the reboot sequence is complete it is recommended that you perform a “Walk Test” to verify that
all transmitters are operational in the system.
A hard reboot can also be performed locally at the Gateway using the following procedure.
Step Step Step Step Action Action Action Action
1. Remove the rear Gateway’s cover, the panel’s tamper alarm will sound.
2.
Using a precision screwdriver, paperclip or equivalent, depress the center (Reboot) recessed
microswitch to reboot the panel.
REAR COVER
SCREW
DETAIL A
MICROSWITCHES
RJ45
ETHERNET
RECEPTACLE
POWER SUPPLY
RECEPTACLE
BATTERY
RECEPTACLE
g
w
-ke
yp
a
d
-0
0
5
-V0