Sensing and Internet of Things
5
Installation and Technical Manual for the
Limitless™ Multi-Protocol Receiver, WMPR Series
ISSUE B
32309669
2 | SPECIFICATIONS,
CERTIFICATIONS, AND APPROVALS
2.1 | Intended Country Usage
Table 3. North America; Country Code Use “A”
Country
ISO 3166 2 letter code
UNITED STATES
US
CANADA
CA
Table 4. Asia Pacific; Country Code Use “B”
Country
ISO 3166 2 letter code
AUSTRALIA
AU
,
ATTENTION
Contact Honeywell before use of the WMPR in countries not
listed in Tables 3 and 4.
2.2 | Certifications and Approvals
See product labels for applicable approvals and ratings.
Table 5. Communication Approvals and Standards
Approval/Item
Ratings/Descrip-
tion
Enclosure type
IP20
Federal Communications Commission
(FCC)
FCC Part 15.247:
2014
Industry Canada (IC)
Canadian RSS-210:
2010
Australian Communications and
Media Authority (ACMA)
C-Tick mark
EtherNet/IP™
General purpose discrete I/O
(GEN code Version 1 only)
ODVA conformant™
m
WARNING
The WMPR must be installed in accordance with the
requirements specified in this document in order to
comply with the specific Country Communication Agency
requirements. (i.e. FCC, IC, ACMA, etc.) See Section 3 as it
requires choosing the correct Country Use Code and thus
allowable antenna and/or cable usage.
m
WARNING
•
The cable length of the customer-supplied dc power
source to the WMPR supply terminals cannot exceed
three (3) meters.
•
The WMPR must be used indoors.
•
The WMPR must be used inside a cabinet and can only
be accessed during set-up or maintenance.
2.3 | Radio Module Specifications
Table 6. Radio Module Specifications
Item
Specification
Radio module
Honeywell RF-PCBa
Wireless standard
WPAN IEEE 802.15.4 Direct Se-
quence Spread Spectrum (DSSS), 2.4
GHz
Data rate
250 kbps
Operating
frequency
ISM 2.4 GHz
Module transmit
power
Country use code “A”
Power level, 11 dBm
Country use code “B”
Power level, 6 dBm
Receive sensitivity
(typ.)
-100 dBm
# of pairing (max.)
Up to 14 Limitless™ inputs can be
paired to a single WMPR
2.4 | Electrical Specifications
Table 7. Electrical Specifications
Item
Specification
Supply voltage
10 Vdc to 30 Vdc
Supply current
500 mA max.
Output type
EtherNet/IP™
Termination
Cage-clamp connector block
m
WARNING
The cable length of the customer-supplied dc power source
to the WMPR’s supply terminals cannot exceed three (3)
meters.
