Sensing and Internet of Things
7
Installation and Technical Manual for the
Limitless™ Multi-Protocol Receiver, WMPR Series
ISSUE B
32309669
•
Intentional or unintentional changes or modifications
must not be made to the WMPR unless under
the express consent of the party responsible for
compliance. Any such modifications could void the
user’s authority to operate the equipment and will void
the manufacturer’s warranty.
2.10.2 | Industry Canada (IC) Compliance
Statements
•
To reduce potential radio interference to other users,
the antenna type and its gain should be chosen so
that the equivalent isotropic radiated power (EIRP)
is not more than that permitted for successful
communication.
•
Operation is subject to the following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including
interference that may cause undesired operation of
the device.
•
This Class A digital apparatus has been tested and
found to comply with Canadian RSS-210:2010.
•
This radio transmitter (identify device by certification
number) has been approved by Industry Canada to
operate with the antenna types listed below with the
maximum permissiable gain indicated. Antenna types
not included in this list, have a gain greater than the
maximum gain indicated for that type, are strictly
prohibited for use with this device
- Antenna type approved for use: Omni
- Antenna gain (max.): 9 dBi
•
Pour réduire les interférences radio potentielles aux
autres utilisateurs, le type d’antenne et son gain
doivent être choisis de telle sorte que l’équivalent
isotrope puissance rayonnée (PIRE) ne est pas
supérieure à celle permise pour une communication
réussie.
•
Son fonctionnement est soumis aux deux conditions
suivantes:
(1) ce dispositif ne doit pas causer d’interférences et
(2) cet appareil doit accepter toute interférence, y
compris les interférences qui peuvent causer un
mauvais fonctionnement de l’appareil.
•
Cet appareil numérique de classe A est conforme avec
Industrie Canada RSS 210: 2010.
•
Cet émetteur radio (appareil identifié par numéro de
certification) a été approuvé par Industry Canada
pour fonctionner avec les types d’antenne répertoriés
ci-dessous et présentant le gain maximal admissible
indiqué. Utiliser des types d’antennes non mentionnés
dans cette liste ou présentant un gain supérieur au
maximum indiqué pour ce type est strictement interdit.
- Type d’antenne approuvé : Toutes directions
- Gain d’antenne (max.) : 9 dBi
2.10.3 | Radio Frequency (RF) Safety
Statements (FCC & IC)
To comply with FCC’s and Industry Canada’s RF exposure
requirements, the following antenna installation and device
operating configurations must be satisfied.
•
Remote antenna for this unit must be fixed and
mounted on outdoor permanent structures with a
separation distance between any other antenna(s) of
greater than 20 cm [7.87 in] and a separation distance
of at least 20 cm [7.87 in] from all persons.
•
Furthermore, when using an direct-mount antenna
with the WBX, it must not be co-located with any other
antenna or transmitter device and it must have a
separation distance of at least 20 cm [7.87 in] from all
persons.
