13
Vigilon fire alarm system
How to manually raise an alarm of FIRE
If you see a
fi
re in the protected premises and want to raise a
fi
re
alarm to warn occupants in the building, you can do this manually by:
Going to the nearest manual call point that is located away from
the
fi
re hazard.
Press hard with a thumb onto the centre of the glass until it breaks.
Panel
buzzer
Previous
Next
1
Zones
Fault
System Fault
Delay
Test
Fire
Power
Power Fault
Verify
Disablement
Sounder
First Fire occurred at:
Time: 15:43.10 Mon 16 March 2015
1stFIRE:MCP:Zone 1
15:45
Manual Call point
The ‘Zone indicators’ are not applicable
for Vigilon Network Node
On
Flashing
Active
Fault/Dis
Fire Routing O/P
If configured this light indicates there is an active Fire routing
output to Alarm Receiving Centre to initiate Fire fighting action.
With the panel door open:
To cancel
buzzer
You can stop the panel buzzer from
sounding.
Press:
Cancel buzzer
Display reads: ‘Buzzer cancelled’
To silence
alarms
When the emergency is over the
alarm sounders can be silenced.
Press:
Silence alarms
Display reads: ‘Alarms silenced’
To reset
system
To return the system to normal
condition clear any residual smoke
or heat from sensors and reset
element or replace the glass in any
manual call point where the glass
was broken.
Ensure the
fi
re system is checked
by your servicing organisation if
there has been
fi
re damage in the
protected area.
Press:
Reset
Display reads ‘System being Reset -
please wait....’
Record
the event
Make an entry in the log book of the
event for future reference.
