14
Automatic detection of FIRE
Automatic detection of FIRE
A fire in your protected premises is automatically sensed at any
one of the fire detection devices installed in the building, such as
a sensor or a fire input from an interface. The control panel
actions the alarm sounders in the system and at the same time
gives the details of the fire event. The event indication is repeated
at all repeat indicator panels in the system.
Panel
buzzer
Previous
Next
1
Zones
Fault
System Fault
Delay
Test
Fire
Power
Power Fault
Verify
Disablement
Sounder
First Fire occurred at:
Time: 15:43.10 Wed 16 March 2016
1stFIRE:MCP:Zone 1
15:45
The ‘Zone indicators’ are not applicable at a Vigilon Plus Network Node
On
Flashing
Active
Fault/Dis
Fire
Routing
O/P
If configured this light indicate there is an active Fire routing
output to Alarm Receiving Centre to initiate Fire fighting action.
With the panel door open:
To cancel
buzzer
You can stop the panel buzzer from
sounding.
Press:
CANCEL
BUZZER
Display reads: ‘Buzzer cancelled’
To silence
alarms
When the emergency is over the alarm
sounders can be silenced.
Press:
SILENCE
ALARMS
Display reads: ‘Alarms silenced’
To reset
system
To return the system to normal condition
clear any residual smoke or heat from
sensors and reset element or replace the
glass in any manual call point where the
glass was broken.
Ensure the fire system is checked by
your servicing organisation if there
has been fire damage in the protected
area.
Press:
RESET
Display reads ‘System being Reset -
please wait....’
Record
the event
Make an entry in the log book of the
event for future reference.
