13
1
Replace light bulb (1) with a 21 watt maximum light bulb. Insert bulb into socket.
The light will turn on and remain lit for 2 1/2 minutes when power
is connected.
After 2 1/2 minutes it will turn off.
There are 2 screw terminals (1) on the back of the door control (2). Strip about 6mm of insulation from bell wire (4).
Separate wires enough to connect the white/red wire to terminal screw 1 and the white wire to terminal screw (1).
Backlit door control button:
Fasten to an inside garage wall with sheet metal screws (3) provided with backlit push button. Drill 4mm holes and
use anchors (6) if installing into drywall or concrete. A convenient place is beside the service door and
out of reach
of children.
Multi-function door control (optional):
Insert a small flat head screwdriver into the top of the wall control (10), gently pry the cover off. Fasten to an inside
garage wall with sheet metal screws (8) as follows:
• Install bottom screw, allowing 3mm to protrude from the wall.
• Position bottom of door control over screw head and adjust for snug fit.
• Install top screw with care to avoid cracking plastic housing.
Do not over tighten.
• Replace cover by inserting bottom tabs (9) and snapping into place. To remove cover after mounting, gently pry at
top with paper clip or small flat head screwdriver.
Run the bell wire up the wall and across the ceiling to the garage door opener. Use insulated staples (5) to secure
wire.
The opener quick-connect terminals (7) are located in the recess next to the learn button on the left side panel. Insert
bell wire into holes in the quick connect terminals as follows: red/white to red and white to white.
24
LOCK
LIGHT
8
8
2
1
RED
W HT
LOCK
LIGHT
1
2
3
5
6
8
9
10
4
LOCK
LIGHT
WHT
2
RED
1
1
1
4
3
7
2
25
REPLACE LIGHT BULB
WIRING THE BACKLIT DOOR CONTROL BUTTON OR THE (OPTIONAL) MULTI-
FUNCTION DOOR CONTROL PANEL
Locate door control where the garage door is visible, away from door and door hardware and out
of the reach of children. Mount at least 1.5 m (5 feet) above the floor.
Serious personal injury from a moving garage door may result from misuse of opener. Do not allow
children to operate the door control or transmitter.
Permanently fasten the caution label to the wall near the door control as a reminder of safe operating pro-
cedures.
Содержание HE60ANZ
Страница 2: ......
Страница 20: ...114A3370D 18 2010 The Chamberlain Group Inc ...