Homentry HE60ANZ, Инструкция по установке и эксплуатации

Страница: 8 / 20

3
2
1
50mm
50mm
6
2
50mm
(2")
3
1
4
B
A
3
6
150mm
(6")
1
2
3
5
5
5
5
5
5
1
2
2
1 1
2
NOTE: Refer to vertical centre and horizontal lines
created in step 11 for proper placement of header
bracket.
A . Wall Mount: Centre the header bracket (1) on the
vertical centre line (2) with the bottom edge of the
header bracket on the horizontal line (4) (with the
arrow pointing toward the ceiling). Mark all of the
header bracket holes (5). Drill 4.5 mm (3/16") pilot
holes and fasten the header bracket with wood
screws (3).
B. Ceiling Mount: Extend vertical centre line (2) onto
the ceiling. Centre the header bracket (1) on the ver-
tical mark no more than 150 mm (6") from the wall.
Make sure the arrow is pointing toward the opener.
Mark all of the header bracket holes (5). Drill 4.5 mm
(3/16") pilot holes and fasten the header bracket with
wood screws (3). For concrete ceiling mount, use
concrete anchors (6) provided.
Clearance between highest point of travel and rail
should not exceed 50mm and can be zero when
clearance between door and ceiling is only 30mm.
Position the opener on the floor below the mounting
bracket using some packaging material to protect the
unitʼs cover. Raise the rail the holes in the header sleeve
and the holes of the header to align bracket. Use the
clevis pin (1) provided to join the two pieces, then insert
the fastening ring (2) to secure in place.
Note: To enable the rail to clear sectional door
springs, it may be necessary to lift the opener onto
a temporary support. The opener must secured in
place by means of a support or by being held by
another person.
12
The header bracket must be rigidly fastened to a struc-
tural support of the garage. Reinforce the wall or ceil-
ing with a 40mm (1-1/2") board if necessary. Failure to
comply may result in improper operation of safety
reverse system.
You can attach the header bracket either to the header wall
(1) or to the ceiling (3). Follow the instructions which will
work best for your particular requirements. With the door
closed, mark the vertical centreline (2) of the garage door.
Extend line onto header wall above the door.
Open door to highest point of travel. Draw an intersecting
horizontal line (4) on header wall 50mm or 200mm above
high point to provide travel clearance for top edge of the
door, height depends on door type (refer section 15).
3
1
2
4
11
13
POSITION THE HEADER BRACKET
INSTALL THE HEADER BRACKET
ATTACH RAIL TO HEADER BRACKET