11
1.
2.
3.
Your garage door opener receiver and transmitter are set
to a matching code. If you purchase additional transmitters,
the garage door opener must be programmed to accept the
new remote code.
To program receiver to match additional remote
control codes:
1.Press and hold down the transmitter button you wish to
program to the opener (1).
2.Press and release the program button on the side of the
opener (2).
3.When the opener light blinks, It has learned the code. If
the light bulb is not installed, two clicks will be heard.
To erase all codes from motor unit memory or to
deactivate any unwanted remote, first erase all codes:
Press and hold the program button (2) on opener until the
learn indicator light goes out (approximately 6 seconds). All
previous codes are now erased. Reprogram each trans-
mitter or keyless entry you wish to use.
22
Activate the opener only when door is in full view, free of obstruction and properly adjusted. No one
should enter or leave garage while door is in motion. Do not allow children to operate push but-
ton(s) or remote(s). Do not allow childen to play near the door
WIRELESS PROGRAMMING
Содержание HE60ANZ
Страница 2: ......
Страница 20: ...114A3370D 18 2010 The Chamberlain Group Inc ...