Homentry HE60ANZ, Инструкция по установке и эксплуатации

Страница: 5 / 20

1
2
3
4
5
6
7
8
10
11
12
NOTICE
9
9
1
1
1
4
4
1
5
5
4
6
2
2
4
5
4
3
3
Place rail pieces (1) on a flat surface for
assembly.
Take special note of the raised line on the
rail pieces (4) these lines MUST line up in
order for the rail to fit together properly.
All three rail sections are interchangeable.
Slide rail braces (2) into slots on the sides
of rail.
Make sure small tabs on rail braces (3) are
up against top lip of rail.
Connect rail by sliding other end of braces
into next rail.
Be sure the raised lines that run down rail
sections (4) line up.
Tap rail assembly (5) on a piece of wood (6)
until rail sections are flush.
Repeat for final rail section.
3
ASSEMBLY SECTION
As you proceed with the assembly, installation and adjustment procedures in this manual, you may find it help-
ful to refer back to this illustration of a completed installation.
4
(1) Cable pulley bracket
(2) Trolley
(3) Chain/cable assembly
(4) Rail
(5) Hanging bracket
(6) Power cord
(7) Opener
(8) Light lens
(9) Manual release
rope & handle
(10) Door arm
(11) Door bracket
(12) Header bracket
BEFORE YOU BEGIN
1. Look at the wall or ceiling above the garage door. The header bracket must be securely fastened to structural
supports.
2. Do you have a finished ceiling in your garage? If so, a support bracket and additional fastening hardware (not
supplied) may be required.
3. Do you have an access door in addition to the garage door? If not, Model 1702AML outside quick release acces-
sory is required.
5
ASSEMBLE RAIL
COMPLETED INSTALLATION - ALL PARTS LISTED ARE SUPPLIED IN THE CARTON.