HOLZMANN MASCHINEN BS370TOP, Руководство пользователя

Страница: 39 / 57

CLEANING, MAINTENANCE, STORAGE, DISPOSAL
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at 39
BS370TOP
16.4.1 Clamping the workpiece
 Open the vice with the hand wheel (17)
 Insert workpiece so that it rests against the fixed
jaw.
 Insert workpiece correctly (see figure on the right)
 Protruding workpieces must be supported!
 Move the movable jaws to the workpiece by turning
the hand wheel (17) and leave a gap of approx. 3-4
mm.
 Clamp the workpiece with the quick lock lever (18).
o
After completing the cutting process, the quick
release lever (18) is released and the
workpiece can be removed.
o
When the quick-release lever (18) is released,
the movable jaw opens. The originally
determined distance to the workpiece
remains.
o
This facilitates rapid re-clamping of
workpieces of the same length.
16.5 Adjusting the cutting angle
The cutting angle between vice and saw band can be
adjusted within the specified angle range (see
technical Data).
 The saw arm can be swivelled to the right at an
angle of up to 60°.
 This requires a positioning of the vice to the left.
 Procedure: see 16.4
 If the saw arm is positioned on the left side, it is
possible to cut at an angle of up to 45°.
 This requires a positioning of the vice to the
right.
 Procedure: see 16.4
NOTICE: Take the lower cutting performance for
angle cutting into account (see technical data)!
Swivelling the saw arm
Procedure:
 Turn the saw arm lock lever (19) to the left. Saw
arm can be swivelled.
 Use the handle (20) to turn the saw arm until
you reach the mechanical stop.
 Check if the desired angle corresponds to the
indication on the scale (21).
 Turn the saw arm lock lever (19) to the right.
17 CLEANING, MAINTENANCE, STORAGE, DISPOSAL
17.1 Cleaning
N O T I C E
Wrong cleaning agents can attack the varnish of the machine. Do not use solvents,
nitro thinners, or other cleaning agents that could damage the machine's paint.
Observe the information and instructions of the cleaning agent manufacturer!
Prepare the surfaces and lubricate the bare machine parts with an acid-free lubricating oil.
Regular cleaning is a prerequisite for the safe operation of the machine and its long service life.
Therefore, clean the device after each use of chips and dirt particles.