HOLZMANN MASCHINEN BS370TOP, Руководство пользователя

Страница: 38 / 57

OPERATION
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at 38
BS370TOP
Adjustment
The saw band guide (7) is preset for a saw band
with a thickness of 0.9 mm.
However, if the saw band guide needs to be
adjusted, the following setting should be carried
out:
 The lateral bearings of the saw band guide (7)
can be adjusted by loosening the screw (5) and
the adjusting screw (6).
 Adjust the bearings so that the saw band can
slide smoothly and there is a gap of approx.
0.05mm between the bearings and the saw
band.
 Retighten the screw (5).
 Loosen the screws (8) and adjust the upper saw
band guide.
 Check that there is at least 0.2-0.3 mm space
between the saw band and the upper bearing.
16.3.2 Adjusting the saw band tracking
The saw band tracking has been adjusted in the
factory.
However, if adjustment is necessary because the
saw band does not run centrally on the saw band
wheel, the following steps must be carried out:
 Move the saw arm to its uppermost position, fix it
and close the hydraulic control.
 Remove the rear protective cover of the saw arm.
To do this, loosen and remove all screws.
 Loosen the hexagon head screws (10,11,12) (only
loosen, do not remove).
 Use the adjusting screw (13) to adjust the
inclination of the wheel and thus the saw band
track.
o Tightening the screw (13) moves the saw
band to the shoulder side of the wheel,
o Loosening moves the belt away.
and then re-tighten the hexagon head screw
(13).
 Tighten the hexagon head screws in the following
chronological order (12,11,10).
 Re-install the protective cover of the saw arm.
 Finally the adjustment must be checked, if it is
not yet correct repeat the above steps.
16.4 Adjusting the vice
 Loosen the adjustable vice jaw by turning the
lever (14) counter-clockwise.
 Loosen the vice (16) by moving the lever (15) to
the left.
 The vice (16) can now be pushed into the desired
position, to the left or right.
 To fix the vice, move the lever (15) to the right.
 Fix the vice jaw by turning the lever (14)
clockwise.