HOLZMANN MASCHINEN BS370TOP, Руководство пользователя

Страница: 34 / 57

OPERATION
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at 34
BS370TOP
15.3.1 Establishing the power connection
To connect the machine to the electrical mains, proceed as follows:
 Check that the supply voltage and current frequency correspond to the specifications on
the machine nameplate.
 Use a suitable device to check that the zero connection and earthing are working
properly.
 The power supply circuit must be equipped with overvoltage protection (RCD with
maximum residual current of 30 mA).
 For the required cross-section of the supply cables, please refer to the current carrying
capacity table. (Make sure that the cables are in good condition and suitable for power
transmission. Undersized cables reduce the power transmission and heat up
considerably.)
 Connect the supply cables to the corresponding terminals in the input box (L1, L2, L3, N,
РЕ) - see following figure. If there is a СЕЕ plug, the connection to the mains is made by
an appropriately supplied СЕЕ coupling (L1, L2, L3, N, РЕ).
Plug connection 400V:
5-wire:
with
N conductor 4-wire:
without
N conductor
16 OPERATION
Device to be operated in a perfect state only. Inspect the device visually every time it is to be
used. Check in particular the safety equipment, electrical controls, electric cables and screwed
connection for damage and if tightened properly. Replace any damaged parts before operating
the device.
16.1 Operation instructions
W A R N I N G
Carry out all setting and adjustment work only after disconnecting from the
electrical mains!
N O T I C E
Check the machine before starting work:

Safety devices in place and in good condition

Check saw band for wear and tear and replace if necessary

Check coolant level and fill up if necessary

Check moving parts for ease of movement

Check all components for correct seating and functioning especially the
screws of saw band guard and the lever.

All tool for maintenance/servicing removed from machine.

Place the saw band guard as close as possible to the workpiece
Check before each cut:

Cutting angle correctly adjusted?

Vice fixed?

Make sure that the material to be machined is properly fixed in the vice.

Mare sure that coolant circulates properly.

Saw band direction correct?
 Long workpieces must be support (eg stand, roll stand,…)
 Always run teh motor at full speed before you start cutting (wait at least 30sec
after starting the saw band)
 Never start the machine with the saw band pressed down (10mm distance)