HOLZMANN MASCHINEN BS370TOP, Руководство пользователя

Страница: 30 / 57

TRANSPORT
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at 30
BS370TOP
14 TRANSPORT
W A R N I N G
Damaged or insufficiently strong hoists and load slings can result in serious injury or
even death. Therefore, check hoists and load slings for sufficient load capacity and
perfect condition before use. Attach the loads carefully. Never stand under suspended
loads!
To ensure proper transport, also observe the instructions and information on the transport
packaging regarding centre of gravity, attachment points, weight, means of transport to be used
and the prescribed transport position, etc.
Before unpacking, transport the delivered
product with a lift truck or stacker to the
desired installation site.
If you transport the machine with a vehicle, make sure that the load is properly secured, and
secure the wheels so that the machine remains fixed in position!
Lifting out of the packaging for assembly and positioning at the workplace: Only by means of
suitable lifting equipment!
The machine is heavy. Load lifting slings are required to remove it from the packaging. They can
be attached underneath the table to lift the machine from the transport pallet.
Note that any lifting equipment used (crane, forklift, sling, etc.) must be in perfect condition.
15 ASSEMBLY
15.1 Preparatory activities
15.1.1 Delivery content
Please check the product contents immediately after receipt for any eventual transport damage or
missing parts. Claims from transport damage or missing parts must be placed immediately after
initial machine receipt and unpacking before putting the machine into operation. Please understand
that later claims cannot be accepted anymore.
15.1.2 Workplace requirements
The workplace has to fulfill the requirements.
The ground has to be even, in level and hard. It must be suitable at least to weight it with double
weight per square meter than the machines net weight.
The chosen workplace must have access to a suitable electric supply net hat complies with the
machines requirements.
You must also secure a distance of at least 0.8 m around the machine all around. In front of and
behind the machine, the necessary distance for feeding long workpieces must be provided.
15.1.3 Cleaning the machine
Remove the corrosion protection agent that is applied to the parts without painting. This can be
done with the usual solvents. Do not use nitro solvents or similar agents and under no
circumstances use water.
15.2 Assembly
The machine comes pre-assembled, it is necessary to reassemble the components that have been
disassembled for transport according to the following instructions.