Compass
™
Stainer Operator’s Manual page 31
If the user presses ‘0’ to indicate that a new step is not needed, the system returns to the last screen
displayed. To end the review, press STOP to exit.
Insert a Step
While reviewing a program, you can insert a step just above the step that you are reviewing. Press
PROG key to start inserting a step and fill in the Station, Time, Criticality, Dip and Exit fields, as
shown on page 8.29. All fields must be entered, or a system warning appears:
When all fields for the inserted step are complete, press the
↓
arrow to review any steps remaining in
the program.
If editing was made to the program during a review, a message will be displayed when STOP is
pressed, prompting the operator to save or clear the edits:
ADD ANOTHER STEP?
1 = YES
0 = NO
Press 1 to add another step
Press 0 for no new step
(return to previous screen)
STEP IS NOT COMPLETE
ENTER: FINISH STEP
CLEAR: QUIT NOW!
Press ENTER to finish the
step (and any remaining
steps, too)
Press CLEAR to quit
immediately (no changes
made)
ENTER: KEEP CHANGES.
SAVE PROGRAM.
CLEAR: LOSE CHANGES.
DO NOT SAVE!
