page 30 Compass
™
Stainer Operator’s Manual
The following screen is shown.
The user can save the program by pressing the ENTER key and the screen shown above will be
displayed while the system is saving the program in the non-volatile memory.
Once the program is saved, the Standby screen is displayed.
Review and Edit a Program
An existing program can be reviewed and edited by the user by pressing the REVIEW key followed
by the program number. The system will check memory for existence of that program.
The first step of the selected program is displayed in the same manner as if a new step was being
programmed as explained above, however, the previously saved parameter values of the step are
displayed. The user can navigate the steps by pressing up or down arrow keys, can change the
parameter values or exit as explained before.
In the event the down arrow key is pressed when the last step is being displayed, the system asks if a
new step needs to be added at the end by displaying the following screen.
ENTER: KEEP CHANGES.
SAVE PROGRAM.
CLEAR: LOSE CHANGES.
DO NOT SAVE!
Press ENTER to save
program
Press CLEAR to exit
without saving program
SAVING PROGRAM IN
NONVOLATILE MEMORY
PLEASE WAIT.
WARNING: DELETING
CANNOT BE UNDONE
ARE YOU SURE?
1: YES, DELETE
2: NO, DON’T DELETE
Saving the program
Deleting the program