WATER SYSTEMS — 6
154
2008 IMPERIAL
Maintenance - Checking for Leaks:
Back of toilet:
Check water supply line
connection. Toilet tissue works well to
fi
nd leaks. The tissue changes texture
when contacting moisture.
Between closet
fl
ange and toilet:
Con
fi
rm that
fl
ange screws are snug.
DO NOT
over tighten screws. If leak
continues, remove toilet and check
fl
ange height. Adjust the
fl
ange height to
7/16" above
fl
oor, if necessary. Replace
fl
ange seal.
Maintenance - Bowl Problems:
Poor
fl
ush:
Flush should be obtained
within two to three seconds. If a problem
persists, adjust the water level. If
problems continue, the water pressure or
fl
ow rate may be low. Remove the water
supply line and check
fl
ow rate. Flow
rate should be at least ten quarts (9.5
liters) per minute. Water pressure should
not be below 25 psi.
Bowl will not hold water:
Check for
foreign material in the ball valve.
NOTE:
If the motorhome is in storage for six
months, spray silicone on the ball valve.
Perform this maintenance monthly
during use (silicone will evaporate
in about 30 days). DO NOT use a
petroleum-based lubricant as damage to
the seals will occur.
TOILET - TECMA
The Tecma is an electric macerating toilet.
Only
fl
ush organic material and toilet paper to
avoid damage. Ensure the house batteries are
charged and interior house power is on.
Water Saver Flush:
Press and release left button. This mode
is recommended for
fl
ushing liquids and
small amounts of toilet paper only.
Normal Flush:
Press and release right button. This mode
is recommended for
fl
ushing solids and
toilet paper.
Empty Bowl:
Press both buttons simultaneously and
release. This empties the bowl and leaves
it dry for travel.
Press either button once to add water and
return to normal use.
Programming Water Level
The water level in the bowl can be
programmed. The minimum recommended
re
fi
ll level is ½" above the bowl outfall hole
(see illustration). It may be necessary to reset
the water level after switching water sources
(from city to fresh tank or vice versa).
Setting the water level:
Press both buttons and hold.
The LED’s will
fl
ash, indicating the
toilet is in program mode.
As water enters the bowl, release buttons
to set the level of standing water in the
bowl. The level will remain constant
after each
fl
ush until a different water
source is used.
Tank Level Sensors
The Tecma toilet system includes a black
tank level sensor. The water icon located in the
bottom right corner of the control panel denotes
tank level and system status.
040466e
040466c
Содержание Rambler Imperial 2008
