31
ACCESSORIES
PRO 60 (110) HP / HPP 700/1.5
to bring the lower, upper, and side bearings in close contact with the plate (
3
).
Tighten the upper bearings in this position.
Fig. 18.
Mounting the guide
Attach the guide to the machine with M8x16 screws and washers (
4
) using the
6
mm
hex
wrench, then tighten the wing screws
1
to press the die to the plate. Next,
raise the restrainer (
6
) to position it 2 mm (0.08’’) above the plate (
7
).
Retract the punch from the plate and move the machine to the next
center--punched mark. If the mark is at a different distance from the plate face than
the mark of
the
base
hole is, loosen four M8x16 screws (
4
), adjust the position of the
guide and tighten the screws in this new position.
The machine with the mounted guide and positioned on a plate must always be
held with both hands. During moving the machine in direction
8
, press the machine
against the face of the plate.
4.6. Tool box
Designed for storing tools. Mount on the power pack with two M6x12 screws using
the 4 mm hex wrench.
2
1
3
4
5
7
6
8
Part number:
SKR-0517-92-00-00-0
(two M6x12 screws included)
Attach the guide to the machine with M8x16 screws and washers (4) using the 6 mm hex
wrench, then tighten the wing screws 1 to press the die to the plate. Next, raise the restrainer
(6) to position it 2 mm (0.08’’) above the plate (7).
Retract the punch from the plate and move the machine to the next center--punched
mark. If the mark is at a different distance from the plate face than the mark of the base hole
is, loosen four M8x16 screws (4), adjust the position of the guide and tighten the screws in this
new position.
The machine with the mounted guide and positioned on a plate must always be held with
both hands. During moving the machine in direction 8, press the machine against the face of the
plate.
