25
PRO 60 (110) HP / HPP 700/1.5
The included equipment consists of:
Crane base
1 unit
Crane arm
1 unit
Left support
1 unit
Right support
1 unit
M8x16 screw
16 units
8.5 mm round washer
16 units
Gas spring unit
1 unit
Locking pin
2 units
44 mm washer
2 units
Pivot pin
1 unit
13 mm round washer
2 units
9 mm clip
2 units
M6x20 handlever
1 unit
6.4 mm round washer
1 unit
Locking plate
1 unit
To mount, screw
the
crane
base
into
top
holes on both power pack sides
with
eight
M8x16 screws and 8.5 mm washers (
1
, Fig. 11) using the 6 mm hex wrench. Use
next eight M8x16 screws and 8.5 mm washers (
2
) to screw the supports with the
locking pins placed as shown in detail
3
into lower holes on both sides of the power
pack.
Then,
remove
the
pins,
slightly
tilt
the
power
pack
backwards,
and
rotate
the
supports according to the arrow direction
4
to rest the power pack on the wheels.
The included equipment consists of:
To mount, screw the crane base into top holes on both power pack sides with eight
M8x16 screws and 8.5 mm washers (1, Fig. 11) using the 6 mm hex wrench. Use next eight
M8x16 screws and 8.5 mm washers (2) to screw the supports with the locking pins placed as
shown in detail 3 into lower holes on both sides of the power pack. Then, remove the pins,
slightly tilt the power pack backwards, and rotate the supports according to the arrow direction 4
to rest the power pack on the wheels.
ACCESSORIES
PRO 60 (110) HP / HPP 700/1.5
Fig. 11.
Mounting the crane base and the supports
Lock the supports in this position by placing the pins in location
1
from Fig.
12. To
join the crane arm to the crane base, put two 44 mm washers (
2
) between the base
and
arm,
and
insert the pivot pin (
3
). Next, at both sides put 13 mm round washers (
4
),
and place the 9 mm clips (
5
) into the grooves of the pivot pin.
3
4
1
2
1
2
3
4
5
