30
ACCESSORIES
PRO 60 (110) HP / HPP 700/1.5
4.5. Guide
Allows guiding the machine along the workpiece.
Dismount
the
depth stop by unscrewing four screws using the 6 mm hex wrench.
Then, position the machine on the plate and use DOWN button to slightly penetrate
into a previously center-punched mark on the plate (
1
, Fig. 17). Use the wrench to
facilitate lowering the restrainer as far as possible (
2
), which will press the plate
to the die (
3
).
Fig. 17.
Positioning the machine on the plate
Loosen the wing screws (
1
, Fig. 18) fully and use the 10 mm hex wrench to
loosen the upper bearings
2
. Next, position the guide on the machine in such a way
Part number (for PRO 110 HP):
PRW-0507-90-00-00-0
(two special washers included)
1
3
2
PRO 60 (110) HP / HPP 700/1.5
4.5. Guide
Allows guiding the machine along the workpiece.
Dismount
the
depth stop by unscrewing four screws using the 6 mm hex wrench.
Then, position the machine on the plate and use DOWN button to slightly penetrate
into a previously center-punched mark on the plate (
1
, Fig. 17). Use the wrench to
facilitate lowering the restrainer as far as possible (
2
), which will press the plate
to the die (
3
).
Fig. 17.
Positioning the machine on the plate
Loosen the wing screws (
1
, Fig. 18) fully and use the 10 mm hex wrench to
loosen the upper bearings
2
. Next, position the guide on the machine in such a way
Part number (for PRO 110 HP):
PRW-0507-90-00-00-0
(two special washers included)
1
3
2
4.5. Guide
Allows guiding the machine along the workpiece.
Part number (for PRO 110 HP):
WAD-HPP1030
(two special washers included)
Dismount the depth stop by unscrewing four screws using the 6 mm hex wrench. Then, position
the machine on the plate and use DOWN button to slightly penetrate into a previously center-
punched mark on the plate (1, Fig. 17). Use the wrench to facilitate lowering the restrainer as far
as possible (2), which will press the plate to the die (3).
Loosen the wing screws (1, Fig. 18) fully and use the 10 mm hex wrench to loosen the upper
bearings 2. Next, position the guide on the machine in such a way to bring the lower, upper, and
side bearings in close contact with the plate (3). Tighten the upper bearings in this position.
