18
START UP AND OPERATION
PRO 60 (110) HP / HPP 700/1.5
hex wrench. During the punching process, the bottom surface of the restrainer must
be in full contact with the workpiece.
Fig. 7.
Positioning the machine on the plate
3.4. Punching
Operate
the machine by holding both handles. The continuous LED light indicates the
machine is ready to operate. Press and hold the DOWN button to move the punch
toward the plate. This will be indicated by the LED flashing every 0.25 seconds.
When the punch reaches the plate, the automatic punching process will start and will
STOP/UP
DOWN
depth stop screws
3.3. Positioning
Hang the machine on the chain and position on a plate with the restrainer retracted above
the punch tip as shown in Fig. 7. Set the position of the hole to be made in relation to the
edge using the depth stop by loosening the four screws using the 6 mm hex wrench. During
the punching process, the bottom surface of the restrainer must be in full contact with the
workpiece.
