Hog Technologies HT1000SR, Руководство по эксплуатации

Страница: 50 / 90

50
Section 4 - Maintenance
5. Once the brass back-up ring is removed, in-
spect the swivel seal seat and the edges of
the seat in the back-up ring closely. If there
is any sign of wear or damage, replace the
brass back-up ring. It is recommended that
the back-up ring be replaced every 3rd or 4th
swivel seal replacement.
6. Insert the swivel seal removal tool into the
bottom of the worn swivel seal and turn coun-
terclockwise until the tool grips the swivel seal.
Continue turning the tool counterclockwise
while pulling on the swivel seal until the seal
is removed.
7. Make sure all debris has been cleaned out of
the swivel seal adapter and the thrust housing
cap at the top of the thru-shaft motor.
8. Apply a small amount of silicone grease on the
O-ring for the swivel seal and on the swivel tit.
This provides lubrication for the seal and swivel
tit at startup when the swivel seal connection
and thru-shaft are dry.
9. Install the brass back-up ring onto the swivel
tit with the beveled seat facing up. Make sure
the brass back-up ring is seated completely.
10. Install the lubricated swivel seal onto the
swivel tit with the beveled edge facing down.
Be sure the swivel seal is seated against the
brass back-up ring.
11. Make sure the swivel seal adapter is perfectly
aligned with the thru-shaft motor and install
the swivel seal adapter onto the thru-shaft
motor.
12. Hand tighten the swivel nut.
NOTICE:
IT IS vERY IMPORTANT TO KEEP THE AdAPTER ALIGNEd
STRAIGHT RELATIvE TO THE THRu-SHAFT PuMP WHILE
PuSHING THE AdAPTER OvER THE SWIvEL SEAL ANd
ONTO THE THRu-SHAFT COvER HOuSING. IF THE AdAPTER
IS NOT STRAIGHT, THE SWIvEL TIT COuLd BECOME BENT
OR BROKEN duRING INSTALLATION.
NEvER uSE TOOLS TO TIGHTEN THE SWIvEL NuT. THE
SWIvEL SEAL ANd NuT WILL BE dAMAGEd IF THE NuT IS
TIGHTENEd MORE THAN HANd TIGHT.