Hofmann geodyna optima, Дополнительные инструкции, Страница: 38 / 62

36
Error Codes
geodyna optima Operator’s Manual
•
check the inner scanner CCD board
•
switch power off and on again; should the
problem not go away please call service.
E373
Inner scanner not calibrated
Possible causes:
•
the inner scanner has not been factory
calibrated
Corrective actions:
•
please call service and replace the inner
scanner.
E374
Inner motor current sink or power supply failure
Possible causes:
•
the cable connecting the camera controller
board and the inner scanner motor is
unplugged, damaged or missing
•
the motor power supply is not configured
properly
•
there is a fault in the motor power supply board
•
the cable connecting the mains supply and the
motor power supply board is unplugged,
damaged or missing
•
there is a fault in the inner scanner motor
• there is a fault in the camera controller board
motor drivers
Corrective actions:
• check all items above.
E375
Inner scanner zero mark not detected
Possible causes:
• the flat cable connecting the camera controller
board and the inner scanner CCD board is
unplugged, missing or damaged
• there is a fault in the inner scanner CCD board
• the inner scanner is locked
• the inner scanner zero mark is missing, bent,
locked or damaged
• the cable connecting the camera controller
board and the inner scanner motor is
unplugged, damaged or missing
• there is a fault in the motor power supply board
• there is a fault in the inner scanner motor
• there is a fault in the camera controller board
motor drivers
Corrective actions:
• check all items above.