Hofmann geodyna optima, Дополнительные инструкции, Страница: 30 / 62

28
Operational Selections
geodyna optima Operator’s Manual
11.1-14
11.1-12
11.1-13
F6
F6
11.1-15
Optimise vibrations
As an alternative to the mounting recommendation for
the set of wheels to minimise the PULL, you can select
a different set-up, suggested to reduce the vibrations
caused by any residual unbalance on the wheels in the
Set.
• Press key F6 to view the recommended
mounting option for optimising vibrations (Fig.
11.1-12).
If you follow this mounting diagram the driver's side of
the vehicle will benefit by feeling the least possible
vibrations.
Note : The different mounting suggestions which can
be selected are not correlated.
You must choose one of the recommended
mounting options, depending on the
priority correction requirement for the
vehicle in question.
•
Press key F6 again to view the mounting
recommendation for PULL optimisation seen
before (Fig. 11.1-13).
Note : Key F6 allows you to toggle between the
different mounting options.
The icon on the top left of the screen
indicates the type of optimisation referred
to by the mounting order shown at that
time.
Enter fifth wheel
(Fig. 11.1-14)
The Set of Wheels procedure in the OPTI LINE mode
allows the entry of a fifth wheel in the set, to guarantee
greater scope for improvement.
WHEEL No. 5
• Perform the procedure as described for wheel
No. 2.
When you enter the 5th wheel in the Set the "SET OF
WHEELS 5" screen page appears automatically (Fig.
11.1-15) and the selection of the best four wheels is
shown, with their relative positions on the vehicle, taken
from the set of five wheels processed.
Note : No further wheels can be entered in the Set.
If you try to enter another wheel the
machine starts the procedure for a new
Set of Wheels and all of the data relative
to the previous Set will be deleted.