Hofmann FPA12144, Инструкция по эксплуатации

Страница: 25 / 44

25 of 44
7.14 OPERATION TEST WITH VEHICLE
1.
Lower lift to ground.
2.
Drive vehicle on to lift, install wheel chocks (Front & Back).
3.
Raise lift to and lower onto 3-4 lock positions during full rise to ensure all locks are
working correctly.
4.
Double check level of runways, front to rear and side to side while on locks.
5.
Re-adjust cables if necessary while vehicle is on.
6.
Check lowering speed and smooth decent rate.
7.
Lower lift to ground, remove wheel chocks and drive vehicle off lift.
If any problems occur during the final checkout or operation of the lift please contact customer
service at 1-800-268-7959
8.0 RECOMMENDED INSPECTION AND MAINTENANCE
8.1 LUBRICATION SPECS
Where hydraulic oil is required > ISO 32 10W ‐ non detergent hydraulic oil
Where grease is required > multi ‐ purpose lithium grease
Where multipurpose lube is required > multi ‐ purpose SAE 30 lubricating oil
Where pneumatic oil is required > Snap ‐ On air motor oil IM1PT
Where cable lube is required > 2001 MONOLEC
®
wire rope lubricant or equivalent
If you are not completely familiar with automotive lift maintenance
procedures, STOP. Contact Snap ‐ on Equipment Technical Support for
instructions. To avoid personal injury, permit only qualified lift service personnel to perform
maintenance on this equipment.
Always raise lift when cleaning floor area with solvents and/or cleaning compounds.
Always replace cable break safety springs when replacing cables.
Please refer to the following table for specific inspection and maintenance frequency.