HMS S3086, Инструкция по эксплуатации

Страница: 8 / 15

PARTS
ASSEMBLY INSTRUCTIONS
The Mini Stepper S3086 is 99% assembled. You will only need to:
STEP 1 . Open the Computer (Part: 33), Install the battery into the correct position (Pic.: 1)
STEP 2 . Connect the Computer (Part: 33) with main frame cable (part: 22) (Pic: 2)
STEP 3 . Install the Computer (Part: 33) into main frame (Part: 1) (Pic: 3)
STEP 4 . Product Installation FOR OPTIONAL PARTS ( ropes )
- Take out the ropes (Pic: 4)
- Fasten the ropes with main frame (Part:1)(Pic:5)
- Make sure the ropes fasten correctly on main frame. (Part:1) (Pic:6)
-
OPERATION
– shift between up-down and twist exercises
1. Up-down Exercise: Insert the locking pin (34) into the upper hole. ( See the picture 1)
2. Twist Exercise: Insert the locking pin (34) into the lower hole. (See the picture 2)
NOTE: to insert the pin without any problems, the pedals have to be on the same level and closely above the rear
stabilizer!
NO. DESCRIPTION QTY. NO. DESCRIPTION NO.
1 Main frame 1 18 Snap Ring 2
2 End cap 4 19 Plastic washer (L) 1
3 Steel plate 1 20 Flat washer 2
4 Cross Screw 2 21 Plastic cover 2
5 Lower front tube 1 22 inner hexagon screw M8x20 2
6 Shaft sleeve 3 23 Pedal (L+R) 2
7 Magnet 1 24 Cross Screw 4
8 Upper Front tube 1 25 Pedal Support(R) 1
9 Shaft sleeve
5
26 Plastic washer (R) 1
10 Plastic protection for sensor
1
27 Hydraulic cylinder 2
11 Plastic fix for sensor 1 28 Flat washer
φ
8 4
12 Cross Screw 1 29 Nut M8 4
13 Flat washer 4 30 Inner hexagon screw M8x40 2
14 Inner hexagon screw M8x25 1
31 Nut M8 2
15 Pedal Support(L) 1 32 Sensor 1
16 Rubber stopper 2 33 Computer 1
17 Bushing 2 34 Locking Pin 1
Pic. 1
Pic. 2
Pic. 3
Pic. 4 Pic. 5 Pic. 6