Operation—Operating The Machine
TX14740,0001FB6
–19–09JAN03–1/2
Backhoe Control Lever Pattern Conversion—Machine Equipped With Excavator Front
Only—Zaxis 200LC, 250
1
C
D
A
B
T144944
T144944
–UN–30AUG01
Control Lever Pattern Conversion, Front View Shown
1—Pilot Signal Manifold
B—Port B
C—Port C
D—Port D
A—Port A
1. Lower bucket to the ground.
2. Stop the engine. Remove the key from switch.
CAUTION: High pressure release of oil from
pressurized system can cause serious burns
or penetrating injury. The hydraulic tank is
pressurized. Slowly loosen hydraulic cap to
vent pressure in the hydraulic tank.
3. Vent pressure in hydraulic tank. (See Vent
Hydraulic Oil Tank Pressure in section 3-3.)
4. Remove panel on top of machine to access pilot
signal manifold.
NOTE: DO NOT use manufacturer’s hose tags or
markings on hose ends to identify hoses for
this conversion procedure. The conversion
must be done on the side of flow regulator
valve that is connected to the pilot controllers.
5. Disconnect and connect hoses on the pilot
controller side (FRONT) of the pilot signal manifold
as follows:
•
Switch hose to Port A (A) with hose to Port D
(D).
•
Switch hose to Port B (B) with hose to Port C
(C).
2-2-15
081407
PN=68
Continued on next page
Содержание Zaxis 200LC
