5
ENGLISH
WARNING
►Install the projector in a stable horizontal position.
►Place the projector in a cool place, and ensure that there is sufficient ventilation.
Keep a space of 30 cm or more between the sides of the projector and other objects
such as walls. Do not place or attach anything that would block the lens or vent
holes. Do not place the projector where the air from an air conditioner or similar unit
will blow on it directly.
►Do not place the projector anyplace where it may get wet.
►Use only the mounting accessories the manufacturer specified, and leave installing
and removing the projector with the mounting accessories to the service personnel.
►Read and keep the user's manual of the mounting accessories used.
►Do not install, move or adjust the product in high places yourself. Leave it to your dealer.
►Before installing the projector in high places, make sure the cover is not attached
to the pen sensor.
CAUTION
►Avoid placing the projector in smoky, humid or dusty place.
►Position the projector to prevent light from directly hitting the projector’s remote sensor.
►If the projector is used at an altitude of about 1600 m or higher, set FAN SPEED
of the SERVICE item in the OPTION menu to HIGH. Otherwise, set it to NORMAL.
If the projector is used with a wrong setting, it may cause damage to the projector
itself or the parts inside.
Arrangement
Refer to table T-1 and figures F-1 and F-2 at the end of this manual to determine the screen
size and projection distance.
The values shown in the table are calculated for a full size screen: 1280 x 800
a
Screen size (diagonal)
b1 , b2
Projection distance (±8%)
c1
,
c2
Screen height (±8%)
• For the case of installation in special conditions such as on the wall or ceiling, the
specified mounting accessories (
20
) and service may be required. Tabletop use must
be set up with the designated optional accessories(
20
). Before installing the projector,
consult your dealer about your installation.
•
The screen position may shift after installation if the projector is mounted on locations such
as the wall or ceiling, due to the flexibility of the plastic projector body. If readjustment is
necessary, consult with your dealer or service personnel.
•
The projected image position and/or focus may change during warm-up (approx. 30
minutes after the lamp is turned on) or when the ambient conditions change. Readjust
the image position and/or focus as necessary.
•
Since the projector features an ultra short throw, be aware that it is required to select a
screen carefully to have better performance.
- A soft screen such as a pull-down screen may cause serious distortion of a projected
image. A hard screen such as a board screen is recommended for use with this projector.
- A high-gain screen such as a bead screen that has narrow viewing angle is not suitable
for this projector. A low-gain screen (around 1.0) such as a matte screen that has wide
viewing angle is recommended for use with this projector.
- A screen with a weave pattern may cause moiré on the projected image, which is not a failure
of the projector. A screen that has less moiré effects is recommended for use with this projector.
• The projector may make a rattling sound when tilted, moved or shaken,
since a flap to control the air flow inside of the projector has moved. Be aware that
this is not a failure or malfunction.
NOTE
