85
7.4 Command Control via the Network
You can configure and control the projector via the network using RS-232C
commands.
Communication Port
The following two ports are assigned for the command control.
Command Control Settings (
51
)
4) Click the
[Enable]
check box to open
Network Control Port1 (Port: 23)
to use
TCP #23. Click the
[Enable]
check box for the
[Authentication]
setting when
authentication is required, otherwise clear the check box.
5) Click the
[Enable]
check box to open
Network Control Port2 (Port: 9715)
to
use TCP #9715. Click the
[Enable]
check box for the
[Authentication]
setting
when authentication is required, otherwise clear the check box.
6) Click the
[Apply]
button to save the settings.
Configure the following items from a web browser when command control is used.
Example
: If the IP address of the projector is set to
192.168.1.10:
1) Enter
“http://192.168.1.10/”
into the address bar of the web browser.
2) Enter your user name and password, and then click the
[OK]
.
3) Click the
[Port Settings]
on the main menu.
7. Other Functions
TCP #23
(Network Control Port1 (Port: 23))
TCP #9715
(Network Control Port2 (Port: 9715))
• Command control is available only via the specified port above.
NOTE
