67
NETWORK menu
Remember that incorrect network settings on this
projector may cause trouble on the network. Be sure
to consult with your network administrator before
connecting to an existing access point on your network.
Select “NETWORK” from the main menu to access
the following functions.
Select an item using the ▲/▼ cursor buttons on the
projector or remote control, and press the ► cursor button on the projector or
remote control, or
ENTER
button on the remote control to execute the item. Then
perform it according to the following table.
See the
User’s Manual - Network Guide
for details of NETWORK operation.
NETWORK menu
• If you are not utilizing SNTP (
Date/Time Settings
in the
User’s
Manual - Network Guide
), then you must set the DATE AND TIME during the
initial installation.
• The network communication control is disabled while the projector is in
standby mode if the STANDBY MODE item of SETUP menu is set to SAVING.
Please connect the network communication to the projector after setting the
STANDBY MODE to NORMAL (
47
).
• Performance may suffer if the image displayed from the
LAN
Port is used
while using Interactive Function. It is recommended to use
COMPUTER IN
or
HDMI
connection.
NOTE
Item
Description
SETUP
Selecting this item displays the SETUP
Menu for the network.
Use the ▲/▼ buttons to select an item,
and the ► or
ENTER
button on the remote
control to perform the item.
DHCP
(Dynamic Host
Configuration
Protocol)
Use the ▲/▼ buttons to turn DHCP on/off.
ON
OFF
Select OFF when the network does not have
DHCP enabled.
• When the “DHCP” setting changes to “ON”, it
takes a little time to obtain IP address from DHCP
server.
• Auto IP function will be assigned an IP address if
the projector could not obtain an IP address from
server even if DHCP is “ON”.
(continued on next page)
