Service Manual
DS 350 GM
Rev A 05/01/01 // SB
190113_A
4
3.2
ERROR CODE DISPLAY
PROBLEM: Error code displayed. Lever lockout activated. Warning lights on.
ERRO
R
CODE
ERROR
CAUSE
ACTION
E01
Minimum radius or
maximum angle range
exceeded
Fallen below the minimum
radius or above the angle
given in the load chart due to
raising the boom to far.
Lower boom back to a radius or
angle given in the load chart.
E02
Maximum radius or
minimum angle range
exceeded
The maximum radius or
minimum angle given in the
load chart was exceeded
due to lowering the boom too
far.
Raise boom back to a radius or
angle given in the load chart.
E03
Prohibited slewing
range (no load area)
Slewing range prohibited
with load.
Slew back into admissible range.
E04
Operating mode not
available
Operating mode switch in the
console set incorrectly.
Operating mode is not
permissible with actual crane
configuration.
Set operating mode switch
correctly to the code assigned to
the operating mode of the crane.
E05
Length range not
permitted
Boom has been extended
too far or not far enough.
Length sensor adjustment
changed; i.e. length sensor
cable slid off the cable drum.
Refer to Section 3.7.
Retract or extend boom to
correct length given in the load
chart.
E06
Fallen below angle
range with luffing jib
operation.
Fallen below the minimum jib
angle specified n the
respective load chart due to
luffing out the jib too far.
Luff in the jib to a radius or angle
specified in the load chart.
E07
No acknowledgment
signal from overload
relay (K1).
Overload relay is stuck,
defective or not being
selected.
Replace main board in central
unit. Refer to Drawing 4 and
Procedure 3 in Section 5.3
E08
No acknowledgment
signal from Anti-Two-
Block switch relay
(K2).
Anti-Two-Block switch relay
is defective or not being
selected.
Replace main board in central
unit. Refer to Drawing 4, Section
4.4, and Procedure 3 in Section
5.3.
E10
Error in length
measurement
With the boom fully
retracted, the length differs
by more than 2%.
Refer to Section 3.7.
38 Years Specializing
in Crane Electronic Repair & Parts Sales
Call Us. We are glad to help
Bode Technical Services Inc
Email: [email protected]
Phone No.: +1.303.433.8878