![background image](http://html.mh-extra.com/html/cisco/telepresence-touch/telepresence-touch_installation-manual_67765001.webp)
A
Connecting the touch screen via LAN
The touch screen can be connected to the following codecs via LAN. The codec
may be part of a Profile system.
•
Codec C20
•
Codec C40
•
Codec C60
•
Codec C90
Check the system information page on your codec to make sure its software
version is TC4.1 or later. If not, contact your Cisco representative.
1.
Restart the codec before you proceed with the installation.
2.
Connect the touch screen cable to the Power adapter.
3.
Connect the shielded Ethernet cable between the Power adapter and the LAN
(Ethernet) socket.
4.
Connect the supplied power cable between the Power adapter and the power
socket. Once power is connected, the touch screen start-up procedure begins.
Wait while the touch screen initializes. Continue when the
Select codec to pair
with
window appears. This may take a few minutes.
Note:
The touch screen obtains its IP settings automatically from the network
(DHCP). In most cases this is preferred and you can continue with the pairing.
If you need a static IP address for your touch screen perform the steps described in
the
Change the IP settings
section, before continuing.
7.5 m
5 m
Power
adapter
Power socket
LAN socket
(Ethernet)
1.8 m
A list of all codecs that are in Pairing mode is displayed on the touch screen.
5.
Click the codec name in the list.
Note:
If your codec is not in the
list, read about
What to do if your
codec is not listed
below.
6.
Review codec details and click
Start Pairing
to start the pairing
process.
7.
If required, the touch screen
downloads and installs new
software from the codec. The
touch screen automatically
restarts after the software
upgrade. This process may take a
few minutes.
If your codec is password
protected, you will be prompted
for an administrator username
and password to sign in to the
codec.
Continue when the menu and
contact list appear on the touch
screen.
8.
Verify that the touch screen is successfully paired to your codec by checking the
codec address displayed in the top banner.
The touch screen is ready to use.
Refresh list
Select codec to pair with
Select codec manually...
IP Settings
System name (Codec type)
The touch screen
menu and contact list
Available
12:00
Product:
Cisco TelePresence System Codec
SIP URI:
H323 id:
Software:
TC4.1.0
IP address:
192.168.1.128
Serial number:
CBA123456789
System name (Codec type)
Start Pairing
Back
This box contains:
•
Cisco TelePresence Touch with cable (7.5 m / 25 ft)
•
Power adapter
•
Power cable (1.8 m / 6 ft) (included when Touch is shipped as a stand-alone unit)
•
Shielded Ethernet cable (5 m / 16 ft)
•
Cleaning cloth
Compatibility
The touch screen is used with the Cisco TelePresence Codec C Series. These
codecs are also used in the Cisco TelePresence System Profile series. The touch
screen can be installed in two ways:
A.
Connecting the touch screen to a codec via LAN (local area network).
B.
Connecting the touch screen directly to the codec.
Note:
The codec software version must be TC4.1 or later.
Safety requirement
You have to use a shielded Ethernet cable (as supplied).
User documentation
User documentation for Cisco TelePresence products, including compliance and
safety information, is found on
http://www.cisco.com/go/telepresence/docs
.
78-19948-01 JANUARY 2011.
Copyright © 2010-2011 Cisco Systems, Inc. All rights reserved.
Cisco TelePresence Touch
For C Series
iNstALLAtioN guide