Removing the mast
element transport
safety hook:
2. Grip the safety bar at the BOTTOM (d) and
pull it towards you until it is able to pass by
the mast system (e).
Repositioning the
mast element
transport safety
hook:
3. Maintain a firm grip on the bottom of the
safety bar and move the TOP of the safety
bar to the first mast section (in the direction
of the winch).
4. Release the grip on the BOTTOM of the
safety bar and slide the TOP of the safety
bar slowly into the first mast section.
Lowering the
carriage:
1. Lower the carriage (a) slightly to loosen the
saftey bar (b) on the carriage. This is done
by winding the crank handle on the winch a
little to the right.
WARNING:
The greater the distance between the load and the carriage, the lower the allowed loading capacity!
See load centre chart
.
Glass and Material Lift
GML 800+
Always ensure that the lift is in the correct operating position and that the saftey brakes on the wheels
and swivel casters are engaged before attempting to dismantle or refit the mast element transport safety hook.
a)
b)
Front view
d)
Fitting the mast element transport safety
hook
In order to reset the mast element transport
safety hook, repeat the above steps in reverse
order:
1. Grip on the bottom and pull.
2. Slip the hook past the mast system.
3. Refit the safety bar at the front, above the c
carriage.
4. Wind the winch slightly to the left.
(Raise the carriage)
Side view
e)
Disengaging/Re-engaging the Mast Safety Hook
Removing/fitting the safety bar
c)
1)
36
Operation Manual
GML 800+
GML 800+
