Hioki PW3336-01, Инструкция по эксплуатации

Страница: 64 / 206

3.2 Configuring Settings
58
4
Press or and set the num-
ber in the area to 2.
The number 2 will flash, and the
AVG
lamp will light up.
When the setting is changed to a value other than
the default setting of 1, the
AVG lamp will light up.
• Averaging will restart when there is a change that affects measured values, for example in the wiring
mode, range, integration reset, or number of averaging iterations. Since no average value exists immedi-
ately after the start of averaging, the invalid data display [
- - - - - ] will be shown. During this period of time,
the AVG lamp will flash.
• If the instantaneous value changes to [ o.r ] while average values are being displayed, the display will
change to [ o.r ].
• The unit may flash during measurement.
See: "3.11.3 When the Unit Indicator Flashes" (p.116)
• Averaging processing is performed for voltage, current, active power, apparent power, and reactive power.
• The power factor and phase angle are calculated from the averaged active power and apparent power.
5
Press to exit the settings.
The instrument will revert to the normal measure-
ment state.
This indicates that the number of averaging iterations cannot be changed.
After pressing to exit the setting, perform the following procedure:
Status Solution and reference for more information
During integration operation
(
RUN
lamp lit up or flashing)
Averaging cannot be changed until the integrated value is reset (so that the
RUN
lamp turns off).
See: Canceling integration (resetting integrated values) (p.65)
During display hold operation or
maximum value/minimum value
hold operation (
HOLD, MIN,
or MAX
lamp lit up)
Averaging cannot be changed until this operation is canceled (so that the
HOLD
lamp turns off).
See: Canceling the display hold state (p.108)
Returning to the instantaneous value display (p.109)
If the number of average iterations does not flash