Hioki LR8431, Инструкция по эксплуатации

Страница: 61 / 204

3.4 Setting Configuration 2 – Input Channel Settings
53
3
3
Chapt
er
3 Sett
ing be
fore M
easure
ment
Configure these settings for each pulse channel receiving input from a pulse
output device such as a watt-hour or flow meter.
Use the scaling function to display integrated pulse counts as the correspond-
ing physical units (such as Wh or VA) of the measurement parameter (p. 58).
Integration (Count) Measurement Settings
• When using the scaling function, the integrated pulse count can
be displayed after conversion to the measurement target’s prop-
erty (Wh, VA, etc.). (p. 58)
• The count will be saturated when the pulse count exceeds
1,073,741,823. If there is a possibility that this number may be
exceeded, it is recommended to set the integration mode to
instantaneous and tabulate the results later with Excel or a simi-
lar application.
1
Select a channel (
P 1
to
P 4
) for the
[Chan-
nel]
setting contents.
2
To enable measurement on the channel,
select On to display the check mark (
).
3
Select
[Count]
for the
[Input]
(input type)
setting.
4
Select the measurement method from the
[Count Mode]
settings.
Setting options:(

default setting)
5
Select the basis of measurement from the
[Slope]
settings.
Setting options:(

default setting)
Add * Counts the number of pulses acquired
from the start of measurement.
Inst Counts the number of pulses acquired dur-
ing each recording interval. The pulse
count is reset at the beginning of each re-
cording interval.
 
Counts the number of L - H transitions.

Counts the number of H - L transitions.
Totalized
[Add]
Instantaneous
[Inst]
0 V
L
H
1 2
: On
: Off
3 4 5