Hioki LR5092, Инструкция по эксплуатации

Страница: 84 / 148

7.2 Setting the Collector from the LR5000 Utility Program
78
Scaling (set as needed)
The following scaling calculation is applied to measured values.
Scaled Result = Raw data (measured value) × A + B × SI prefix (multiplier)
The scaled result is displayed on the logger.
1. Set the following options.
2. Confirm the settings.
3. Click the [Save] button.

(Scaling settings are saved, and the display returns to the Logger Settings screen.)
Note: If you click the [Cancel] button without saving the settings, the display still returns to
the Logger Settings screen.
See:
"What is Scaling?" (p.79)
Enable scaling
Select this check box to enable scaling.
Clicking this tab
changes the setting
options. Make set-
tings on either tab.
(The settings are
applied to the other
tab.)
Specify by example, or Specify by A/B
Setting Item Setting Description
Specify by

example
Enter two known conversion points (up to ten digits each).
Specify by A/B Enter the scaling coefficients (A and B, up to ten digits each).
Scaled units
• Select the [SI Prefix] .

( [p] =1E-12, [n] =1E-9, [

] =1E-6, [m] =1E-3, blank =1E0, [k] =1E3, [M] =1E6,
[G] =1E9, [T] =1E12)
• Enter the [Char. String] to identify the scaled units.

(Up to five characters, except \, /, :, *, ?, ", <, >, and |.)
Display digits
• Select [Fixed decimal point] and specify the [Decimal digits] to be dis-
played to the right of the decimal point. Valid settings are 0 to 3.

(Examples: selecting 0 displays values in the form 0000, and selecting 3 dis-
plays values in the form 0.000)
• When [Fixed decimal point] is not selected, values are displayed as four dig-
its (0.000 to

9999) with automatic decimal positioning.
Setting

confirmation
Confirm that scaling is performed properly.
Enter any numerical value as raw data, and click the
[Calc] button to display the
scaled result.