Hioki BT3564, Инструкция по эксплуатации, Страница: 195 / 210

Appendix 8 Zero Adjustment
A
13
Appendi
x
To perform zero adjustment using Z5038 0 ADJ Board
When performing zero adjustment, you cannot use a metal board or similar
object to replace Z5038 0 ADJ Board.
The zero adjustment board is used when performing zero adjustment of L2100,
L2110 Pin Type Lead.
Table 3 shows cross sectional diagrams and equivalent circuits of the two con-
nection methods: connecting Pin Type Lead to zero adjustment board, and con-
necting that to a metal board or similar object. Table 1 (a) indicates the
connection using zero adjustment board, resulting in 0 V between SENSE-H and
SENSE-L. However, Table 1 (b) is the connection using a metal board or similar
object, so that 0 V is not obtained between SENSE-H SENSE-L.
Table 3: Pin type lead connection methods in zero adjustment
Connection method
If connection is made using
Z5038 0 ADJ Board
If connection is made using
metal board or similar object
Tip of lead
Equivalent circuit
Deformed equiva-
lent circuit
As connection meth-
od for zero adjust-
ment
Correct Wrong
Pattern
(conductive layer)
HIOKI BT3564A961-02