HIMA HIMatrix F3 AIO 8/4 01, Руководство пользователя

Страница: 37 / 56

F3 AIO 8/4 01 4 Start-up
HI 800 161 E Rev. 2.00 Page 37 of 56
4.3.3.2 Tab
AO 4: Channels
The
AO 4: Channels
tab contains the following system parameters:
System
parameter Data
type R/W Description
-> Error Code
[BYTE] BYTE R Error codes for the analog output channels
Coding Description
0x01 Fault in the analog output unit
0x80
-> Value [INT]
out of the specified range
-> Value [INT] INT R Output value of AO channels:
Current characteristic curve: 0...+2000 (0...+20 mA)
Current characteristic curve: -2000...0 (0 mA)
Before being normalized, the values are checked for plausibility.
Current characteristic curve:
 Values < 0:
are normalized to 0
 Values < intermediate data point LOW:
Normalization with intermediate data point LOW
 Values > intermediate data point HIGH:
Normalization with intermediate data point HIGH
Outputs must not be used as safety-related outputs!
Channel Used
[BOOL] -> BOOL W Channel configuration:
1 = operating
0 = not operating
Table 32: SILworX - System Parameters for Analog Outputs,
AO 4: Channels
Tab
4.4 Configuration with ELOP II Factory
4.4.1 Configuring the Inputs and Outputs
The signals previously defined in the Signal Editor (Hardware Management) are assigned to the
individual channels (inputs and outputs) using ELOP II Factory. Refer to the system manual for
compact systems or the online help for more details.
The following chapter describes the system signals used for assigning signals in the remote I/O.
4.4.2 Signals and Error Codes for the Inputs and Outputs
The following tables specify the system signals that can be read and set for the inputs and
outputs, including the corresponding error codes.
In the user program, the error codes can be read using the signals assigned within the logic.
The error codes can also be displayed in ELOP II Factory.