HES HS1102S, Руководство пользователя

Страница: 3 / 35

Hwang Sun Enterprise Co., Ltd. Edition 2012/06 2
CHAPTER 1 SAFETY SUMMARY
1-1 INTRODUCTION
This chapter is to provide related safe precautions while doing installation, operation and
maintenance of HS1102S hot melt applicator to prevent personal and equipment’s risk. These
safe precautions can be classified as following:
1.1
Safety during installation
1.2
Safety during equipment operation
1.3
Safety during maintenance
1.4
Safety during use of hot melt adhesive and solvent
1-2 Safety during installation
1)
A correct and effective grounding line must be installed when installing the hot melt
applicator. Without it, any isolation component would still be conductive, resulting in
shock hazard.
2)
Check whether the power cords and their isolation protection match requirement according
to the load of the hot melt applicator and its accessories.
3)
Ensure that a switch with a thermal safety cut-off is installed between the apparatus and
the primary generator.
4)
Ensure that the hot melt applicator is working under the proper voltage. This hot melt
applicator may be burned by using wrong voltage.
1-3 Safety during operation
1)
Avoid operating the hot melt applicator near the volatile or explosive materials and gases.
2)
DO not operate the equipment without the covers, panels and safety guards properly
installed.
3)
Do not operate the machine when the ambient temperature is below 0 or above 50 .
℃ ℃
4)
To prevent heating hose cannot cool down, please do not put heating hose inside
container.
5)
Make sure heating hose is not touched by ground while using longer heating hose.
6)
Any cooling on surface of heating hose may cause circumstance that the hot melt glue
inside heating hose get unstable flow.
7)
Hot melt glue amount would be affected by dispensing nozzle exposing to ventilation.
(Temperature will instantly cool down)
1-4 PRECAUTION DURING OPERATION
1)
Do not use the equipment as a ladder or stepping tools.
2)
Prevent heating hose from getting twist and damaged on surface while installation and
operation.
3)
Use only the metal base when attempting to lift or move applicator. Do not use