HERO IGNITOR TECHNO, Руководство пользователя

Страница: 56 / 71

52
CAUTION
! !
•
Do not attempt to start or ride the vehicle
without a charged battery, it can cause
fusing of the bulbs and permanent damage
to certain electrical components.
•
Turn the ignition switch "OFF" before
checking or replacing the fuse to prevent
accidental short-circuiting.
WARNING
! !
•
Never use a fuse with a different rating from
that specified. It may lead to serious damage
to the electrical system or a fire due to short
circuit.
•
Battery gives off explosive gases. Keep
sparks, flames & cigarettes away.
The stop lamp switch (1) must be adjusted so
that stop lamp will glow when rear brake is
applied. Rear brake free play
(page 42)
should be adjusted before performing stop
lamp switch adjustment. The procedure for
adjusting stop lamp switch is as follows :
Stop lamp switch
(1) Stop lamp switch (2) Adjusting nut
(A) Advance (B) Retard
2
1
A
B
•
Turn the ignition switch to the “ON”
position.
•
Turn the adjusting nut (2) to position stop
lamp switch at a point where the stop lamp
will glow just before the brake pedal is
depressed to the limit of its free play.
Headlamp is factory preset. However in case
of adjustment required, please follow the steps
as given below:
Headlamp focus adjustment
•
Turn the adjusting nut in direction (A) to
advance switch timing or in direction (B) to
retard switch timing.
•
Headlamp adjustment is done by the
headlamp adjusting bolt (1) located below
headlamp.
•
Park the vehicle on level ground.
•
Tighten the bolt after adjustment.
•
Adjust the headlamp beam vertically by
loosening the bolt (1) and move the
headlamp unit forward and backward for
correct focus adjustment.
(1) In circuit fuse: 20A (2) Spare fuse: 20A
1
2 B