HERO IGNITOR TECHNO, Руководство пользователя

Страница: 21 / 71

17
NOTE
•
If the battery voltage is low, the i3s system
will not work. The i3s indicator on the
speedometer console will start to blink, if
the rpm is less than 2000 rpm and the i3s
indicator goes off if the rpm is more than
2000 rpm. The vehicle will be in normal
operating conditions as other vehicles and
no special functions will be performed.
•
If the vehicle is driven without battery or
with the dead battery, the i3s system will not
work. The i3s indicator on the speedometer
console will start to glow continuously.
•
The vehicle will be in normal operating
conditions as other vehicles and no special
functions will be performed.
•
During electric or clutch start, the engine
will cut-off
•
if engine reaches 900 rpm
•
if the relay is engaged for more than 5
seconds.
Fuel tank
•
To unlock and remove fuel tank cap (1), lift
the key hole cover (2), insert ignition key
(3) turn it clockwise and remove the cap.
Fuel tank capacity is 11 litres (minimum)
including reserve supply of 1.4 litre.
less then 2000 rpm with clutch lever/throttle
is in released position) By pressing the clutch
lever, the engine will start again and gear can
be engaged to move the vehicle.
While driving in a traffic jam/or very dense
traffic where the vehicle has to encounter a
stop and go situation, the i3s switch can be
changed to “OFF” position. Once this is done,
the i3s system will not work and the vehicle
Driving with i3s Switch in “OFF”
position:
While driving, if the engine is kept idling (while
waiting in a traf c signal), the engine will cut fi
off in 5 secs. (The vehicle should be in neutral
Initial Activation of the i3s system:
In this condition, the engine can be restarted
either with kick or electric start only.
Keep the i3s switch (1) to “ON” position.
Turn the Ignition key to “ON” position. The
i3s indicator (2) on the speedometer console
will glow for 2 seconds and turn “OFF”. Start
the vehicle and allow the engine to run in
neutral gear position with the rpm less than
2000 rpm. The engine will cut off in 30 secs.
After the rst stop start every subsequent stop fi
will be in 5 secs.
Driving with i3s Switch in “ON”
position:
NOTE
•
Use choke during cold conditions.
•
The engine will stall if the i3s switch is in
“ON” position during warmup.
will be in normal operating conditions as other
vehicles and no special functions will be
performed.