Heras HMD Basic, Руководство пользователя

Страница: 68 / 88

EN – Translation of the original user manual - 2.0 | 2019 68
Reference/
Error no.
Text Meaning
210 Mot.runtime.err. The motor was stopped because the maximum
motor runtime for this gate movement was
reached (limit switch was not reached in the
maximum runtime)
[Gate check required]
211 main-cnt.err. The main loop counter of the motor controller
has overflowed (fatal exception error)
212 Undef.state The variable of the state machine has reached an
invalid value (fatal exception error)
213 Lim.sw.err. The gate did not leave the limit switch within the
maximum permissible time period (4 sec.) (gate
disengaged or very difficult to operate) [gate
check required]
214 < MAINTENANCE >
required One of the specified maintenance events (gate
cycles, maintenance interval) has occurred
215 Limit positions undef. The limit positions of the gate are undefined for
the control system software (e.g. both limit
switch contacts open)
217 EEPR.err.Txt The sought-after display text was not found in
the memory
218 EEPR.err.wr. An error occurred when writing a text into the
memory
219 EEPR.err.language An error occurred in relation to a pointer address
for a text in memory
220 Motor.err. The motor was stopped due to a motor
monitoring signal (return signals not plausible)
224 DC voltage.err The supply voltage at the DC power module is
too low (e.g. current switched off; battery too
weak)
225 DC Fault The DC power module has detected a short
circuit to the motor
226 DC Temp.err: The DC power module has detected an
excessively high operating temperature
228 REL+err.High The voltage monitoring system for the release
signal has measured an excessively high value
229 REL+ Low The voltage monitoring system for the release
signal has measured an excessively low value