Heras HGD230, Руководство пользователя

Страница: 75 / 146

EN – Translation of the original user manual - 2.1 | 2019 75
• Check the traffic light operation.
7.11 TIMER-CONTROLLED GATE MOVEMENTS
Certain gate movements can be started automatically by pre-defined timer
settings. These timer settings per menu must be displayed here.
7.11.1 Setting automatic closing
The motor drive can close the gate automatically after a time as set (1 to 3600
seconds) has elapsed after the OPEN end position was reached. This function is
active only in automatic mode and after the OPEN end position has been reached.
•
Menu: "Settings", "Set timer", "Keep-open TMR": set to "xxx".
Example: If the "Keep-open TMR" parameter is set at value 5, a 5-second timer
is started when the gate reaches its OPEN end position in automatic mode. This
timer causes the gate to be closed automatically again after 5 seconds. If another
OPEN command is given or an installed photocell is activated during this time, the
timer will start to count down again.
This value can be changed by the customer without the need to enter a password.
The TMR automatic closing is not activated when the maximum number of
reversions for the CLOSE movement has been reached:
If the gate moves in the CLOSE direction but does not reach the CLOSED position
because a safety edge is approached in the same direction (no infrared), the gate
will return to the OPEN position. The TMR automatic closing will be activated
again. A similar action can happen at most 5 times in succession. The gate then
remains open and the timer does not start again. Only after a new CLOSE
command is given and after reaching the CLOSED position will the reversing
counter be set to 0 and automatically close again after the next opening.
Attention! If a TMR AUTOMATIC CLOSING IS SET and the gate is in the
OPEN position and the control is restarted (for example, by interrupting
the voltage), THE TMR AUTOMATIC CLOSING IS ALSO RESTARTED. After the
countdown of the timer, the gate will be closed automatically.