Heras HGD230, Руководство пользователя

Страница: 53 / 146

EN – Translation of the original user manual - 2.1 | 2019 53
6.2.2 Stop function
To stop a running motor or to prevent the motor from starting, a STOP button or
switch can be connected to the "In2" input. This element must be designed as a
normally closed contact. It is also possible to connect several NC circuits in series
in the form of a STOP chain (eg motor temperature switch, access switch, STOP
button). Contacts can also be connected to the backplane; see appendix B and C.
•
Switch off the power supply to the motor drive.
•
Connect the STOP button to the input IN2 and the +24 Volt (normally
closed contact).
•
Switch on the power supply of the motor drive.
6.2.3 Emergency stop function
An emergency stop function is pre-installed at input In6. When the input
(normally closed contact) is activated, a stop is immediately activated. It is no
longer possible to move the motor. When the input is deactivated, the program of
the controller performs a reset. Contacts can also be connected to the backplane;
see appendix B and C.
• Switch off the power supply to the motor drive.
• Connect the EMERGENCY button /switch tot he input IN6 and to +24 Volt.
•
Switch on the power supply of the motor drive.
6.2.4 Open, close controls
OPEN and CLOSE keys can be connected to drive the gate by hand. The inputs
referred to below have already been factory-configured for the relevant functions
and do not require any further settings to be made. The function at this input is
only supported in automatic mode. Contacts can also be connected to the
backplane; see appendix B and C.
Proceed as follows to connect the keys:
•
Switch off the power supply to the motor drive.
•
Connect the keys to the 24V power supply.
•
Connect the OPEN key to input terminal In1 (make contact).
•
Connect the CLOSE key to input terminal In3 (make contact).
•
Switch on the power supply of the motor drive.
• Check that the keys work.