Heras HGD230, Руководство пользователя

Страница: 70 / 146

EN – Translation of the original user manual - 2.1 | 2019 70
this example we describe the installation and setting procedures for Rel4. Lights
can also be connected to the backplane; see appendix B and C.
• Switch off the power supply to the motor drive.
• Connect the lamp to the output relay Rel4.
•
Switch on the power supply of the motor drive.
•
Menu: "Service Menu", "Enter passw.": enter the password.
•
Menu: "Settings", In/Outputs“, „OUT Rel5“: set to „21“
•
Menu: "Settings", "Set timer", "Lighting (s)": set at the required time (in
seconds). The value must be greater than 0, otherwise the relay will not
be activated.
The lamp connected to "Rel4" is now switched on by the motor drive as soon as a
movement command is detected. After the motor is switched off, the lamp will
continue to be lit for the time as set (1 to 1800 seconds).
This parameter "Lighting (s)" can be changed by the customer without the need to
enter a password.
7.8 PROGRAMMING SERVICE INTERVALS
The HMD230 can indicate two different gate states via relays.
At the factory, the output relay "Rel2" is set so that it is closed when the OPEN
position of the gate is reached. The output relay "Rel3" is set so that it is closed at
"Gate CLOSED".
Settings on the control are not necessary.
7.8.1 Cycle counter
A maintenance message can be displayed after a certain number of gate
movements. When the defined number of door movements is reached or
exceeded, the "Maintenance request" event is activated in the control system. The
message appears on the display during an active maintenance message.
< Maintenance >
request
Upon delivery, the value for the number of gate movements is set to 30,000. The
maintenance message can be set as follows: