Heras HGD230, Руководство пользователя

Страница: 52 / 146

EN – Translation of the original user manual - 2.1 | 2019 52
Ill.Nr. Terminal
number
Marking Input function
25 3 In8 Hold to run button OPEN (e.g. Key switch
on the gate)
25 4 In7 Hold to run button CLOSE (e.g. Key
switch on the gate)
25 5 In6 Emergency stop
25 6 In5 Partly OPEN pulse (pedestrian passage)
25 7 In4 TOGGLE pulse (OPEN / STOP/ CLOSE /
STOP)
25 8 In3 CLOSE pulse
25 9 In2 STOP button (normally closed contact)
25 10 In1 OPEN pulse
Section 7.14 describes how to assign other functions to the two inputs In5 and
In6. Pre-installed at input In5 is a partial OPEN function and at In6 an emergency-
stop switch.
6.2.1 Installing the dead man’s keys
You cannot put a gate into operation until at least one OPEN and one CLOSED key
have been connected for dead man's operation. Since you cannot set the end
positions without these keys, you have to perform the following actions in the
sequence described below. If a backplane is present, those keys are already
prepared and connected as such.
•
Switch off the power supply to the motor drive.
•
Connect the keys to the 24V power supply.
•
Connect the key for OPEN [dead man's key] to input terminal In8 (make
contact ).
•
Connect the key for CLOSED [dead man's key] to input terminal In7
(make contact ).
•
Switch on the power supply of the motor drive.
•
Check that the keys work.