Henny Penny Velocity OXE-100, Инструкции по эксплуатации

Страница: 72 / 118

Programming
60
Menu Display Name Function
used to access modes such as Product, Cook, Special Program-
ming, etc.
SP-21 CHANGE USAGE
CODE Provides access to change the Reset Usage password code,
which is defaulted to 123 from the factory. The Reset Usage
password code is used to access the usage statistics, it does not
grant any programming privileges.
SP-22 CLEAN-OUT TYPE The Clean-Out function supports two different water based clean-
out modes, Heated and Cold-Soak. Heated is heated and timed
while Cold-Soak is unheated and not timed. KFC software is
hard-coded for Cold-Soak only, it cannot be changed.
SP-23 CLEAN-OUT TEMP
• If Heated mode is selected in the SP-22 menu, operators may
select a temperature between 40°F – 195°F with which to
heat the water. Higher temperatures require Personal
Protective Equipment (PPE) to prevent burns.
• If Cold-Soak mode is selected in the SP-22 menu, this setting
displays Cold-Soak and can not be changed.
SP-24 CLEAN-OUT MINUTES
• If Heated mode is selected in the SP-22 menu, operators may
select a time 1 Min. to 99 Min. The timer starts after the water
is heated to the temperature selected in SP-23. The clean
cycle time allows the amount of time necessary to scrub the
vat and lid before prompting to drain and rinse.
• If Cold-Soak mode is selected in the SP-22 menu, this setting
displays Cold-Soak and can not be changed.
8 8..6 6 F Fiilltte err C Co on nttrro oll
The Filter Control mode allows the parameters during a filter cycle to be modified for the best results
depending on the oil type. Each parameter is grouped into a section that controls a particular
settings. See
Table 8-3 Filter Settings, page 61 . To access the Filter Control menu do the following:
1 1))
Press and hold the menu button until *MAIN* displays.
2 2))
Press the menu button again. The 4. PROG menu displays.
3 3))
Select 4 4.. P PR RO OG G.
4 4))
Type 1 12 23 3. The 6. FLTR CTRL menu displays.
5 5))
Select 6 6.. F FL LT TR R C CT TR RL L.
6 6))
Use the left or right arrow to navigate through the options.